Roman shades are great as they can keep the sunlight out so they are most suitable to be used in bedroom and in places where you want more privacy. In addition installing this type of shades is not difficult. Below are 6 easy steps that you can follow to install your roman shades.

Step 1: You need a manual screw driver or a cordless one with quarter inch hex head bit a measuring tape and a hammer.

Step 2: Then unpack your blinds from the box. Make sure that you take out all the accessories that come with it. Please also read the manual that comes with it just in case they are any special instructions required.

Step 3: You should start with the mounting bracket which goes at the top of your window. Measure and mark around two and half inches in from each site of the window. Line up the bracket on the mark area to make sure that they are even.

Step 4: Then use a starter screw to mark where the mounting screws will go into the bracket. Tap gently using a hammer. Finally fasten the screw in tightly.

Step 5: It’s time to fasten the blinds into the brackets. Just push the head rail of the blinds into the bracket until you hear a clicking sound.

Step 6: Test the blinds by lowering and raising it to ensure everything is fixed properly.

You can also refer to the video below if you need a visual guide on how to do this the right way. Believe me it is not difficult and in no time you will be an expert in this.